New Contact - Charging - Programming Pad Plate with Cable for Minitor V

Description

New
Interface Charging Programming
Pad / Plate with Cable for Minitor V (5).
This is where the charger, programmer, and amp charger interface with the pager.
This pad slips into a holder on your middle casing inside of the pager and the other end of cable solders to your main board.
It is attached to a flat cable.  For just the pad, see this listing here:
http://www.ebay.com/itm/-/262010934904?ssPageName=STRK:MESE:IT
You will get one pad with foam spacer and cable attached.
Pads are Gold plated over Nickel for wear resistance and good connections.
(Not recommended to be replaced by non-technicians)
Pad measures roughly 6.77mm by 18.5mm