New Starter For TECUMSEH SNOWBLOWER 33290 33290A 33290B 33290C 33290D 33517

Description

A starter (also self-starter, cranking motor, or starter motor) is a device used to rotate (crank) an internal-combustion engine so as to initiate the engine's operation under its own power. Starters can be electric, pneumatic, or hydraulic. In the case of very large engines, the starter can even be another internal-combustion engine.
New Starter For TECUMSEH SNOWBLOWER 33290 33290A 33290B 33290C 33290D 33517
A starter (also self-starter, cranking motor, or starter motor) is a device used to rotate (crank) an internal-combustion engine so as to initiate the engine's operation under its own power. Starters can be electric, pneumatic, or hydraulic. In the case of very large engines, the starter can even be another internal-combustion engine.
Internal combustion engines are feedback systems, which, once started, rely on the inertia from each cycle to initiate the next cycle. In a four-stroke engine, the third stroke releases energy from the fuel, powering the fourth (exhaust) stroke and also the first two (intake, compression) strokes of the next cycle, as well as powering the engine's external load. To start the first cycle at the beginning of any particular session, the first two strokes must be powered in some other way than from the engine itself. The starter motor is used for this purpose and it is not required once the engine starts running and its feedback loop becomes self-sustaining.
Starter installation
Clean the armature and external drive mechanism with gasoline first. After cleaning, check whether the drive is flexible; when installing, apply graphite grease between the friction plates of the friction clutch, and apply organic oil to the threaded filament part; the starter is installed on the engine, and the distance between the end face of the driving gear and the plane of the flywheel is 3 5 mm is appropriate to ensure that the gears mesh correctly.
Fault check
The starter often has failures and phenomena that cannot rotate or rotate slowly. In this case, check the following aspects:
1. The battery has no electricity or the electricity is weak, so the starter cannot rotate or rotate slowly.
2. The starter thread is loose or off, and the switch or adsorption switch fails.
3. The brush is worn out or the brush surface is not correct, and the spring is weak, resulting in poor contact of the rectifier.
4. Excitation coil or armature coil is short-circuited or disconnected.
5. The rectifier is fouled and the mica sheet is protruding, causing poor contact between the brush and the rectifier.
Organization maintenance
In the process of starting the engine, the starter must draw in 344~400Ah from the battery. Therefore, in order to prevent the battery from over-current or damage, the starting time should not exceed 5s. In winter, it is easy to start difficult to start. Multiple starting times should not be too long, and appropriate intervals should be left in each starting.
Teeth: 9
Voltage: 120 (Includes extension cord to plug into 110 Volt standard outlet)
Rotation: CCW
Starter Type: DD
Pinion/Splines OD: 26.6mm / 1.047in
Mounting Hole 1: 6.75mm ID - Unthreaded
Mounting Hole 2: 8mm ID - Unthreaded
Mounting Hole 3: 6.75mm ID - Unthreaded
Ariens: 72200600
Arrowhead: STC0015
Cargo: 112569
Dixie: MS-6015, 214-10702
J & N: 410-22032
Lester: 5897, 5897N
Minnpar: 57-5123
MTD: 390-985
Rotary: 10975
Stens: 435-627
Tecumseh: 33290, 33290A, 33290B, 33290C, 33290D, 33290E, 33517
Wilson: 91-35-1020, 71-35-5897
MAKE       TYPE       MODEL       YEAR       ENGINE
Tecumseh H30 All All
Tecumseh H35 All All
Tecumseh HS40 All All
Tecumseh HS50 All All
Tecumseh HXL35 All All
Item Specifics
Brand
X-engineclub
Manufacturer Part Number
X110187EC
Interchange Part Number
72200600 STC0015 112569 MS-6015 214-10702 410-22032
Other Part Number
33290 33290A 33290B 33290C 57-5123 390-985 10975 435-627
Cross Part Number
5897 5897N 33290D 33290E 33517 91-35-1020 71-35-5897
Compatibility
Starter For Tecumseh
UPC
Does not apply
Warranty
1 Year
Fitment Type
Direct Replacement
Condition
New
Surface Finish
New Quality
Teeth
9
Voltage
120
Rotation
CCW
Starter Type
DD
Part Type
Starter
Weight
1.825kg
Package
26.00(L)*15.00(W)*13.00(H)CM
Number of Pieces
1
Non-Domestic Product
No
Custom Bundle
No
Modified Item
No
Position
Front
Payment
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
1.We only accept PayPal.
2.Please do not use the PayPal note field to indicate us to ship to other address. The note there will NOT be read. If you want to change the shipping address, please contact us by eBay messages.
3.(if you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement.)
4.Payment must be received within 10 days as auction ended or order might be delayed.
Shipping
1. Orders processed within 24 hours of payment verification.
2. We only ship to confirmed PAYPAL addresses. Your PAYPAL address must match your Shipping address.
3. The images shown are not the actual item and are for your reference only.
4. If you have not received your shipment within 15 days from payment , please contact us. We will track the shipment and get back to you as soon as possible with a reply. Our goal is customer satisfaction!
Returns
1. You have 30 days to contact us and 10 days to return it from the date it was received. If this item is in your possession more than 7 days, it is considered used and we will not issue you a refund or replacement. There are NO EXCEPTIONS!
2. All returned items must be in the original packaging and you must provide us with the shipping tracking number, specific reason for the return, and item custom lable.
3. We will refund your full winning bid amount, upon receipt of the item in its original condition and packaging with all components and accessories included, AFTER both Buyer and Seller cancel the transaction from eBay. OR, you may choose to have a replacement.
Contact Us
You may contact us via message if you have any questions and we will reply to you within 24 hours from Monday to Saturday.(Excluding local holidays)
Shop Category
Store Home
Starter
Alternator
Oil Pan
Harmonic Balancer
Throttle Body
Turbocharger
Engine Mount
Mass Air Flow Sensor
regulator rectifier
relay solenoid
stator
Crankshaft Position Sensor
camshaft Position Sensor
Throttle Position Sensor
Oil Pressure Sensor
MAP Sensor
car Carburetor
Height Level Sensor
Temperature Sensor
Driveshaft
Catalytic Converter
Steering Rack
Ignition Coil
fuel pump
Other
Hot Item
For Dodge Avenger Caliber Jeep Patriot Compass 2.4L 2007 2008-2012 Throttle Body
USD 46.69
4 Ignition Coil Pack for Buick Regal Verano Chevy Cobalt Equinox L4 2.4L UF491
USD 50.99
For Chevy Trailblazer GMC Envoy 4.2L 2003 2004 2005 2006 2007 Throttle Body
USD 60.99
6 Ignition Coil Pack for Chevrolet Camaro Equinox Impala Malibu V6 3.6L UF569
USD 66.59
6 UF242 Ignition Coil Pack for Honda Odyssey Accord V6 3.0L Acura RL CL TL
USD 59.59
New List Item
Power Steering Rack For FORD F-150 4.2L 4.6L 5.4L 6.2L V6 2009-2010 22-2039
USD 363.19
Direct Replacement Solenoid Relay New Remote 120-105751-6
USD 22.95
Power Steering Rack For DODGE DAKOTA 1997-2000 DODGE DURANGO 1999-2003 22-338
USD 292.69
A5416 A5415 A5417 A5418 For Dodge Caliber Engine Motor & Trans Mount Set 4PCS
USD 80.07
Power Steering Rack For 1998-2011 Cadillac Seville Cadillac DTS Buick Lucerne
USD 254.89
Help & Info
Payment Policy
Shipping Policy
Return Policy
FAQ
About Us
default
10
New Starter For TECUMSEH SNOWBLOWER 33290 33290A 33290B 33290C 33290D 33517
A starter (also self-starter, cranking motor, or starter motor) is a device used to rotate (crank) an internal-combustion engine so as to initiate the engine's operation under its own power. Starters can be electric, pneumatic, or hydraulic. In the case of very large engines, the starter can even be another internal-combustion engine.
Internal combustion engines are feedback systems, which, once started, rely on the inertia from each cycle to initiate the next cycle. In a four-stroke engine, the third stroke releases energy from the fuel, powering the fourth (exhaust) stroke and also the first two (intake, compression) strokes of the next cycle, as well as powering the engine's external load. To start the first cycle at the beginning of any particular session, the first two strokes must be powered in some other way than from the engine itself. The starter motor is used for this purpose and it is not required once the engine starts running and its feedback loop becomes self-sustaining.
Starter installation
Clean the armature and external drive mechanism with gasoline first. After cleaning, check whether the drive is flexible; when installing, apply graphite grease between the friction plates of the friction clutch, and apply organic oil to the threaded filament part; the starter is installed on the engine, and the distance between the end face of the driving gear and the plane of the flywheel is 3 5 mm is appropriate to ensure that the gears mesh correctly.
Fault check
The starter often has failures and phenomena that cannot rotate or rotate slowly. In this case, check the following aspects:
1. The battery has no electricity or the electricity is weak, so the starter cannot rotate or rotate slowly.
2. The starter thread is loose or off, and the switch or adsorption switch fails.
3. The brush is worn out or the brush surface is not correct, and the spring is weak, resulting in poor contact of the rectifier.
4. Excitation coil or armature coil is short-circuited or disconnected.
5. The rectifier is fouled and the mica sheet is protruding, causing poor contact between the brush and the rectifier.
Organization maintenance
In the process of starting the engine, the starter must draw in 344~400Ah from the battery. Therefore, in order to prevent the battery from over-current or damage, the starting time should not exceed 5s. In winter, it is easy to start difficult to start. Multiple starting times should not be too long, and appropriate intervals should be left in each starting.
Teeth: 9
Voltage: 120 (Includes extension cord to plug into 110 Volt standard outlet)
Rotation: CCW
Starter Type: DD
Pinion/Splines OD: 26.6mm / 1.047in
Mounting Hole 1: 6.75mm ID - Unthreaded
Mounting Hole 2: 8mm ID - Unthreaded
Mounting Hole 3: 6.75mm ID - Unthreaded
Ariens: 72200600
Arrowhead: STC0015
Cargo: 112569
Dixie: MS-6015, 214-10702
J & N: 410-22032
Lester: 5897, 5897N
Minnpar: 57-5123
MTD: 390-985
Rotary: 10975
Stens: 435-627
Tecumseh: 33290, 33290A, 33290B, 33290C, 33290D, 33290E, 33517
Wilson: 91-35-1020, 71-35-5897
MAKE       TYPE       MODEL       YEAR       ENGINE
Tecumseh H30 All All
Tecumseh H35 All All
Tecumseh HS40 All All
Tecumseh HS50 All All
Tecumseh HXL35 All All
Item Specifics
Brand
X-engineclub
Manufacturer Part Number
X110187EC
Interchange Part Number
72200600 STC0015 112569 MS-6015 214-10702 410-22032
Other Part Number
33290 33290A 33290B 33290C 57-5123 390-985 10975 435-627
Cross Part Number
5897 5897N 33290D 33290E 33517 91-35-1020 71-35-5897
Compatibility
Starter For Tecumseh
Warranty
1 Year
Fitment Type
Direct Replacement
Condition
New
Surface Finish
New Quality
Teeth
9
Voltage
120
Rotation
CCW
Starter Type
DD
Part Type
Starter
Weight
1.825kg
Package
26.00(L)*15.00(W)*13.00(H)CM
Number of Pieces
1
Non-Domestic Product
No
Custom Bundle
No
Modified Item
No
Position
Front
Payment
Shipping
Returns
Contact Us
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
1.We only accept PayPal.
2.Please do not use the PayPal note field to indicate us to ship to other address. The note there will NOT be read. If you want to change the shipping address, please contact us by eBay messages.
3.(if you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement.)
4.Payment must be received within 10 days as auction ended or order might be delayed.
1. Orders processed within 24 hours of payment verification.
2. We only ship to confirmed PAYPAL addresses. Your PAYPAL address must match your Shipping address.
3. The images shown are not the actual item and are for your reference only.
4. If you have not received your shipment within 15 days from payment , please contact us. We will track the shipment and get back to you as soon as possible with a reply. Our goal is customer satisfaction!
1. You have 30 days to contact us and 10 days to return it from the date it was received. If this item is in your possession more than 7 days, it is considered used and we will not issue you a refund or replacement. There are NO EXCEPTIONS!
2. All returned items must be in the original packaging and you must provide us with the shipping tracking number, specific reason for the return, and item custom lable.
3. We will refund your full winning bid amount, upon receipt of the item in its original condition and packaging with all components and accessories included, AFTER both Buyer and Seller cancel the transaction from eBay. OR, you may choose to have a replacement.
You may contact us via message if you have any questions and we will reply to you within 24 hours from Monday to Saturday.(Excluding local holidays)
All rights reserved.