SNO-WAY SNOWAY Controller Keypad Repair Kit 96107354 96107355

Description

ButtonWorx Button Repair Pad
SNO-WAY
ButtonWorx membrane repair is installed between the original rubber pad and circuit board.
Permanent Repair
Lasts longer than original buttons
Seals out dirt and oils
Easy put in place
Satisfaction Guaranteed!
Installation
IMPORTANT
:
The red and black power wires from the battery pack will break off easily if you bend, tug and pull on them.  You must be extremely careful with the wires, especially if you cannot solder them back on yourself if they break off.
A T-7 Torx bit is needed to take the back cover off.
Also remove the battery cover and batteries.
Peel brown paper off membrane.
It can be difficult to start and you may want to use a sharp blade to grab an edge.
Once you have an edge, the thin brown paper comes off
very
easily
.
If the paper is not removing easily then you are probably peeling the multi-layer keypad apart!!
Use the holes to line up the keypad.
The membrane pad should be installed AS FLAT AS POSSIBLE !!
DO NOT press down hard. Just put in place. The adhesive will keep the pad from moving as soon as it touches.
-
The rubber keypad has 4 pins that poke through holes on the PCB
The PCB needs to be tucked under the battery wires.
The PCB has 4 larger holes that line up with some short posts on the top plastic housing.
There is a small plug for the hole in wireless units