Western Fisher Stik 9800, 96462, 96369, 64294, 9900 Plus Plow 14 Pin Round Plug

Description

Here is a Control to replace the expensive 96462 factory control. This has a round screw on plug with 14 holes but uses only 10 pins. This is used on The Western MVP V plow (also works on Fisher EZ V.) Check your plug. It only fits the MVP, not the MVP Plus or MVP3. This control has designated buttons, so no mode button. It has one button for every function. This comes with a dash bracket. NOTE: There is a modification required for this control to work that you can read about below. It is a simple modification, but it is not a plug-and-go item. For the Installation Instructions and U-Set Settings, check this document. Ground Wire Lead Installation Instructions Control plugs directly into your existing harness, NO adapter required, just Plug-N-Plow Please make sure the connector matches your connector before ordering 4 way operation Automatic Shut-off when not in use, approximately 22 minutes The plow blade will coast to a soft stop (left or right), results in smoother operation and decreased wear on the plows hydraulic system Express Up/Down Feature On/Off switch can be used as an Emergency Stop when required Illuminated keypad on control for night time plowing All control functions will time out (shut-off) after a period of time. This helps reduce wear on the pump motor and prevent unnecessary battery drain, Up-button, times out after 2.6 seconds, while left and right functions time out after 3 seconds Flexible Straight Cord Use for both Left or Right Hand Dash Mount Control Holder Included Instructions come with each control Designed and Manufactured in the U.S.A.